5
Z-6
: 10 meter wired multi-function remote controller with 5-pin plug for ANTARI
Fazer Z-300 model. Its two knobs allow the operator to customize fog machine
functions by adjusting output volume and interval.
1.
Adjust the volume of haze produced (within the range of 0% -100% of
maximum output.) by means of the VOLUME control knob
2.
Adjust the interval between each fog emission (within the range of 10-250
seconds) by means of the INTERVAL control knob.
3.
Press the yellow TIMERS button to activate the timer function. When activated
the yellow light will turn on. Adjusting the interval knob will determine the time
between haze output (10-250 seconds). The duration of output is set at 15
seconds. The volume can be adjusted using the volume knob to control the
amount of haze produced.
4.
Press the red CONTINUOUS button for continuous output. The volume knob
can be used to regulate the volume of the steady stream of haze produced.
5.
When pressed, the green MANUAL button overrides all other function controls,
and activates maximum output. When released, the manual function stops and
the machine will return to the previous setting; timer; continuous; or stationary.
Note
: the Continuous function will override the Timer function. Therefore, if both
buttons have been depressed the Fazer will haze continuously. The manual
function overrides all functions. When depressed and held down the Fazer will
haze at maximum volume for as long as the button is held down, regardless of the
machine’s setting at the time.
Installation
Installing the Fazer
Remove all packing materials from the fazer. Check that all foam and plastic padding is removed, especially
in the nozzle area.
Fill with Fog Liquid (ordercode 60603) or other high-quality water-based fog fluid. Any other types of fluid
can damage the unit. Note the maximum fluid level mark located on the rear of the fazer. Pour fazer liquid
into the liquid tank, being careful not to exceed the maximum fluid level. DO NOT OVERFILL.
When filled, place cap back on liquid tank.
Firmly attach the remote control cable to the proper input on the rear of the machine
The unit can only be operated at floor level or sitting on any regular surface.
It is important that the fog does not shoot directly at any one’s face. Therefore, do not point the nozzle in a
direction that will aim directly at a person.
Whatever installation method you choose, do not allow the unit to have more than a 15 degree angle of
inclination.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Procedure :
1.
Plug power cord into a grounded electrical outlet. If necessary, turn power switch on rear of unit to “ON”
position. The fogger will now warm-up.
2.
To emit fog, press the button on the remote and hold for the desired length of time..
3.
For further information on operating your Antari Fog Machine, see Remote Control Operation.
Remote Control Operation
1 2
3 4 5
Fig. 3
Optional Remotecontrol
:
Z-7:
Wireless remote controller with five-prong plug for Z-300.
