EN
11
ELECTRICAL SAFETY
New installations and
extensions to existing systems
should always be carried out by
an authorised electrician. If you
have the necessary experience
and knowledge (otherwise
contact an electrician), you
can replace power switches
and wall sockets, fit plugs,
extension cords and light
sockets. Incorrect installation
can result in fatal injury and
the risk of fire.
SYMBOLS
Read the instructions.
Approved in accordance with
the relevant directives.
Recycle discarded product
in accordance with local
regulations.
TECHNICAL DATA
Rated voltage
230 V ~ 50 Hz
Max output
Reeled out: 3200 W
Reeled in: 1100 W
Protection rating
IP20
Cord type
H05VV-F 3G1.5 mm²
Cord length
15 m + 1.5 m
INSTALLATION
WARNING!
Check before installing that there are no
concealed electrical cables that can be hit by
the drill or screws.
1. Pull out the plug before installation.
2. Install the product within 0.6 metres of
an earthed power point with a switch.
Install the product on a wall post or other
suitable surface that can withstand the
weight of the product.
3. Use the mount as a template and mark
out the drill holes.
4. Drill holes with a suitable drill and screw
in screws with a minimum diameter
of 10 mm and length of 25 mm (sold
separately). Do not screw in the screws
all the way. Thin screws can result in
the product coming loose and dropping
down, which can cause personal injury
and/or material damage.
5. Hang the product on the screws with
the screws in the thin part of the screw
holes. Put a screw with a diameter of
10 mm and 25 mm long in the round
hole in the middle, and screw tight to lock
the product in place. Pull on the product
outwards and to the sides to check that it
is firmly in place.
6. Plug the plug into the power point.
USE
1. Pull out the power cord to the required
length. The product has a locking function
to prevent the cord reeling in.
2. To reel in the cord, pull it out a little and
then allow it to reel in automatically.
Hold onto the cord as it reels in.
