Anslut 408-054, Operating Instructions Manual

Page: 12 / 14

ENGLISH
12
Connecting the remote control to the receiver.
408-054 can be remote controlled with a wall
switch or handheld remote control.
Linking a code
Place the remote control near the receiver and
press the programming button on the receiver for
3 seconds; the green LED on the receiver starts
to flash slowly. Press the ON button on the
remote control.
Using remote controlled recessed receiver with Off/On function

Press the ON button on the remote control to switch on the light.

Press the OFF button to switch off the light.
The self-programming receiver has two memory settings.

It can be programmed for special effects to suit your requirements.

It can be programmed to switch on once, or to switch on and off in different combinations.
This means that one receiver can be programmed for no more than two different combinations.
For example: Assume that there are three receivers, where receiver 1 controls a table lamp, receiver 2
controls a night light and receiver 3 controls a ceiling light.

Receivers 1, 2 and 3 can be controlled separately, with the remote control buttons 1, 2 and 3.

Receivers 1 and 3 can be programmed with remote control button 1, table lamp and ceiling light
on/off at the same time.

Receivers 1, 2 and 3 can also be programmed for a group function, i.e. all on or off at the same
time (table lamp, night light and ceiling light on or off at the same time) if the remote control has this
group function.
NOTE! Do not programme an Off/On receiver and a dimmer receiver to the same remote control button.
We also recommend that you only programme one dimmer receiver to each remote control button.
LED INDICATOR
PROGRAMMING BUTTON