Anslut 012958, Operating Instructions Manual

Page: 54 / 56

EN
54
Maximal
When the humidity sensor is activated the fan
runs at the speed that gives maximum air flow.
Recommended for bathrooms larger than 6
m
2
.
Quiet
When the humidity sensor is activated the
fan runs in
QUIET mode. Recommended for
bathrooms less than 6 m
2
.
ADJUSTING THE HUMIDITY TIMER
When the humidity has stabilised the timer
starts the countdown and the fan runs for the
set time. The available timer settings are 30,
45 or 60 minutes. The standard setting is 30
minutes. If the humidity changes by less than
20% in 10 minutes the timer is automatically
set to 15 minutes.
On the control panel
Press in the MODE button and press the TIMER
button. This setting cannot be done from the
remote control. Press in the
MODE button
and press the TIMER button once to show the
current setting.
SETTING THE STOP DELAY
When the fan is started with the external
switch the fan runs for the set time and then
returns to the previous mode.
On the control panel
Press the TIMER button and set the stop delay
to 5, 15 or 30 minutes.
On the remote control
Press the button for the required delay in
minutes (5, 15 or 30). Press the
TIMER button
once on the control panel to show the current
setting.
SETTING THE START DELAY
If the bathroom is used frequently for a short
time you can change the start delay so that
the fan does not start and stop too often. On a
signal from the external switch the start delay
counts down and the fan starts after 0, 2 or 5
minutes.
On the control panel
Press the TIMER button and set the stop delay
to 5, 15 or 30 minutes.
On the remote control
Press the button for the required delay in minutes
(5, 15 or 30). Press the
TIMER button once on the
control panel to show the current setting.
ACTIVATION OF 24 HOURS MODE
In this mode the fan runs with minimum air
flow until the humidity sensor or external
switch is activated. Activate the function by
pressing the
24 HOURS button on the control
panel or remote control. The green status
light below the button on the control panel
shows that this mode is activated. Press the
24
HOURS button again to activate this mode. The
function is not available if connected as per
wiring diagram 2.
PAUSE
Press the PAUSE button on the remote control
to stop the fan for 45 minutes, after which the
fan returns to the previous mode. Press the
PAUSE button again to deactivate the pause
mode. This function is only available from the
remote control.