EN
18
Safety class II.
Class III.
Approved as per applicable
directives.
Recycle discarded product
in accordance with local
regulations.
TECHNICAL DATA
Input voltage, transformer
230 V ~ 50 Hz
Output voltage, transformer
12 V DC
Output 20 W
Safety class, transformer
II
Protection rating
IP44
Laser wavelength
532 nm
Output
5 mw
Ambient temperature
-25 – +35°C
DESCRIPTION
1. Projector lens
2. Adjust knob
3. Rubber washer
4. Ground spike
5. Screw
6. Control switch
FIG. 1
ASSEMBLY
1. Remove all parts from the packaging.
2. Fit the product on the ground spike with
the screw, rubber washer and adjust
knob.
3. Press the ground spike firmly in the
ground so that the product is stable.
4. Undo the adjust knob, set the required
angle and tighten.
FIG. 2
5. The product can also be used with the
supplied stand if necessary. In which case,
put the ground spike inside the tube.
USE
1. Adjust the product so that the laser show
is shown on the required surface.
2. Plug in the plug and set the power switch
to ON.
NOTE:
It can take up to 10 minutes for the product
to warm up when it is cold.
3. The product starts and plays for 6 hours,
after which it switches off automatically.
After 18 hours the product starts
automatically again and plays for 6
hours. This cycle is repeated until the
product is switched off.
Summary of Contents for 002-524
Page 3: ...1 1 2 3 4 5 6...
Page 4: ...2 3...
