Anritsu MT9083B2, Operation Manual, Page: 26 / 32

Chapter 3 Operation
3-8
3.4 Analyzing Image of Fiber Endface
3.4.1 Executing analysis
Perform the following steps to set the analysis conditions.
1. Double-click the desired file in the file list and display the image.
2. Selects the ferrule adapter installed to the VIP from the Tip
pull-down menu.
1.25PC-M:
φ
1.25 mm PC Universal
2.5APC-M:
φ
2.5 mm APC Universal
2.5PC-M:
φ
2.5 mm PC Universal
FC-PC-F: For FC connector
LC-PC-F: For LC connector
SC-PC-F: For SC connector
SC-APC-F: For SC connector (APC)
60-LC-PC-F: For 60 degree LC connector
(Selectable when Microscope is set to G0306B)
3. Select the fiber type from the Profile pull-down menu.
SM UPC>45: Single-mode fiber, PC connector with return loss >45
dB
SM APC: Single-mode fiber, Angled PC connector
SM PC>26: Single-mode fiber, PC connector with return loss >26
dB
MM PC 62.5: Multi-mode fiber, Core diameter 62.5
µ
m
MM PC 50.0: Multi-mode fiber, Core diameter 50
µ
m
4. Click Analyze to display the analysis results and evaluation results.
5. If check Show Overlays, the evaluation diagram (circle) for analysis
is displayed on the monitor.
Table 3.4.1-1 Analysis Results
Name Description
Zone Name Name of the analyzed zone
Diameter (
µ
) Measurement result of the diameter
The unit is micrometer (
µ
m).
Result Evaluation result of the diameter
Defects Evaluation result of contaminations or
defects of the fiber connector endface
Count Count of the detected contaminations or
defects
Defects Area (
µ
2
) Total area of the detected defects
The unit is square micrometer (
µ
m
2
).
Scratches Evaluation result of scratches
Count Count of the detected scratches on the fiber
connector endface