Anova MG3514, Instruction And User'S Manual

Page: 12 / 18

5
are not specified by the manufacturer is prohibited.
It is not necessary to press the saw into the cut against the trunk. Apply only light
pressure while running the engine at full speed.
Daily inspection is recommended before use and after drops or other impacts to identify
significant damage or defects.
Loading the engine with the chain caught in a cut can damage the clutch system. When the
saw chain is caught in the cut, do not try to force it out, but use a wedge or pry bar to open
the cut.
- Kickback protector
This saw is also equipped with a chain brake that will stop the chain from kickback
if it works properly. You should check the operation of the chain brake before each
use by running the saw at full speed for 1 or 2seconds and pushing the front hand
guard forward. The chain must stop immediately with the engine running at full
speed. If the chain stops slowly or does not stop, contact the manufacturer's or
importer's service center to replace the brake band and clutch drum before use.
It is extremely important that the chain brake be checked for proper
operation before each use and that the chain be sharp to maintain the
kickback safety level of this saw. Removal of safety devices, improper maintenance, or incorrect bar or
chain replacement can increase the risk of serious personal injury from kickback.
■ felling of a tree
1.
Decide felling direction considering wind, tree support, location of
heavy branches, ease of work after felling, and other factors.
(A)
Felling cut.
(B)
Notch cuts.
2.
As you clear the area around the tree, arrange for a good
foothold and retreat path.
3.
Make a notch one-third of the way into the tree on the felling side.
4.
Make a felling cut from the opposite side of the notch and at a level slightly higher than the bottom of the
notch.
When felling a tree, be sure to warn neighboring workers of the danger.
■ CUTTING LOGS AND LIMBING
1.
Always make sure of your footing, as well as the stability of the tree.
2.
Watch for the rolling of a cut log.
3.
Read the “Safe Operation” instructions to avoid saw kickback.
Before starting work, check the direction of the bending force inside the log to be cut.
Always finish cutting from the opposite side of the bend direction to prevent the guide bar from getting caught in the
cut.