Anova MG246, Instruction And User'S Manual

Page: 8 / 30

By turning the switch to the "O" position, the motor will immediately stop, ”O”
and ”I” are displayed on the switch button.
Position: behind and to the left of the rear handle.
(d). Operate the primer
Pull out the primer button to close it; press it to open it.
Position: r behind and to the left of the rear handle.
(e). Oil pump adjustment
If you turn the rod clockwise with a screwdriver, the oil flow
flows more, and if you turn it counter-clockwise, less.
Position: Bottom of the rear handle.
(f). The screw under the “H” seal is the high speed mix adjusting
screw..
The screw under the "L" is the low speed adjusting screw.
The screw on the "T" is the idle adjustment screw.
Position: above and to the left of the rear handle
(g). Shows the directions in which the chain brake is released
(white arrow) and engaged (black arrow).
Position: Front Handlebar
(h). Shows the installation direction of the chain saw.
Position: In front of the chain cover
(I). Sound level of this equipment.
MG246:113 dB (A)
MG252: 114 dB (A)
(J). Manual engine start.
k) Decompression valve (if included)
Press the button on the decompression valve to open it.