Do not drag the assembled unit across any surface.
•
This product requires only periodic cleaning with a sponge and a solution of mild detergent and water to
•
remove surface dirt. Do not clean with a solvent or petroleum based products.
Furniture must not be used other than for its intended purpose and should be inspected regularly for loose,
•
missing, or broken hardware, and general instability.
Furniture that is damaged or appears to be unstable must be removed from service and be repaired or replaced.
•
Repairs must be made using only factory authorized parts and methods.
•
wArnInG
cAre And
mAIntenAnce
211 No
rth Lindbergh Blvd.
St. Louis, MO 63141
tel: 888.535.5005
web:
anovafurnishings.com
11/2012
Lift the Table Top and move it over the top of the Table Top Pan. Rotate the Table Top until the square frame on the bottom of the
10.
Table Top matches the orientation of the Table Top Pan. Carefully lower the Table Top down onto the Table Top Pan.
Secure the Table Top to the Table Top Pan using the remaining eight 1.5” long Button Head Allen Screws (2 screws on each side)
with a 1/4” Washer on each of the Screws. You may have to lift the Table Top slightly to get the holes to align.
Leave the Screws finger tight until all the Screws are started, then use the 5/32” Allen Wrench to tighten the Screws. Be careful
not to over tighten the Screws; the inserts they thread into could unseat and begin to spin with the Screw.
5/16” Flat
Washer
5/16” Hex
Head Bolt
5/16” Flat
Washer
Flanged Nut
Contour Seat
(Pattern may vary)
Table Top
Table Top Pan
1.5” Long Button
Head Allen Screw
1/4” Flat Washer
1.5” Long Button
Head Allen Screw
1/4” Flat Washer
Place one of the Contour Seats over one of the Seat Mounts. Use four 5/16” Hex Head Bolt with 5/16” Flat Washers (inside and
11.
outside) and Flanged Nuts.
Install the remaining Seats in the same manner.
Move the Table to the location where it will be used.
12.
After two weeks, retighten all hardware.
13.
