3 of 4
Place a 1/4” Flat Washer on the end of one of
7.
the longer (1.5” long) Button Head Allen Screws
and insert the screw through one of the Pan
mounting holes in the outer bolt circle and into
the corresponding threaded hole in the Seat
Support. Leave the Screw finger tight. Repeat
this for the remaining five 1/4” Button Head Allen
Screw locations in the top of the Table Top Pan.
You may have to adjust the Seat Supports or the
Seat Swivel
Seat Support
Mounting Plate
Table Top Pan
5/8” long Button
Head Allen Screw
1.5” Long Button
Head Allen Screw
1/4” Flat Washer
1.5” LongButton
Head Allen Screw
1/4” Flat Washer
1/4” Flanged Nut
Seat Mount
5/8” Long Button
Head Allen Screw
1/4” Flanged Nut
Table Top Pan in order to get the mounting holes to align.
After all the Button Head Allen Screws are installed, tighten
all of the hardware in the Lower Leg Bracket and in the Table
Top Pan. Be careful not to over tighten the Button Head Allen
Screws; the inserts they thread into could unseat and begin to
spin with the Screw.
Locate one of the Seat Swivels. Position the Seat
8.
Swivel on the lower end of one of the Seat Supports so
that the mounting holes in the Seat Swivel align with
the mounting holes in the Seat Support Mounting
Plate.
NOTE: The word “Front” is stamped into the frame of the
swivel. This should be oriented toward the center of
the Table assembly.
Install four of the shorter (5/8” long) 1/4” Button
Head Allen Screws through the bottom plate of the
Swivel and the Support Mounting Plate. Add 1/4”
Flanged Nuts and tighten the Nuts after all four
Screws are installed.
Install the remaining Seat Swivels in the same manner.
The Screw heads must be inside the Swivel and the
Flanged Nuts must be outside of the Swivel for the
Swivel to work properly.
Locate one of the Seat Mounts. Position the Seat Mount on the lower end of one of the Seat Swivel/Seat Supports so that the
9.
mounting holes in the Seat Mount align with the mounting holes in the top plate of the Seat Swivel. Install four 5/8” long Button
Head Allen Screws through the Seat Mount and the top plate of the Seat Swivel, add Flanged Nuts and tighten the hardware
after all four Screws are installed.
Install the remaining Seat Mounts in the same manner. The Screw heads must be inside the swivel and the Flanged Nuts must
be outside of the Swivel for the Swivel to work properly.
