3 of 4
Place a 1/4” Flat Washer on the end of one of the 1.5” long Button Head Allen Screws and insert the Screw through one of the
7.
Pan mounting holes in the outer bolt circle and into the corresponding threaded hole in the Seat Support. Leave the Screw finger
tight. Repeat this for the remaining four 1/4” Button Head Allen Screw locations in the top of the Table Top Pan. You may have
to adjust the Seat Supports or the Table Top Pan in order to get the mounting holes to align.
After all the Button Head Allen Screws are installed, tighten all of the hardware in the Lower Leg Bracket and in the Table Top
Pan. Be careful not to over tighten the Button Head Allen Screws; the inserts they thread into could unseat and begin to spin
with the Screw.
Seat Mount
Seat Support
Mounting Plate
Table Top Pan
5/16” Hex Head Bolt
1.5” Long Button
Head Allen Screw
1/4” Flat Washer
1.5” Long Button
Head Allen Screw
1/4” Flat Washer
Seat Mount
5/16” Flat Washer
Flanged Nut
5/16”Flat Washer
Seat Support
Mounting Plate
Locate one of the Seat Mounts. Position the Seat Mount on the lower end of one of the Seat Supports so that the mounting
8.
holes in the Seat Mount align with the mounting holes in the Seat Support Mounting Plate. Install four 5/16” Hex Head Bolts
with 5/16” Flat Washers (top and bottom) and Flanged Nuts.
Install the remaining Seat Mounts in the same manner.
