Anova H1950, User Manual

Page: 9 / 18

9
Step 3:
Screw the high pressure hose to the gun. Push and turn (clockwise) to prevent
leaks. When the pieces are properly attached, you will not be able to separate
the two components by pulling directly on the gun. Remove counterclockwise.
(Figure 5)
Step 4 (optional accessory):
Attach the detergent nozzle quick connector to the end of the lance by pressing
into place, it will make a clicking sound when firmly in place. To remove the
detergent nozzle, pull back on the lance collar and pull out the detergent
nozzle. (Figure 6).
Connect the hose joint to both ends of the water inlet hose, then connect the
water inlet hose (minimum hose diameter 13mm) to the joint of the water tap and to the
machine (Fig. 7- 9).
Caution: Before connecting the quick connector to the machine, check that the filter is
mounted on the water inlet and that it is not blocked. Failure to adjust filter will damage pump
valves.
Warning: The garden hose can not be damaged or leak, the inner diameter is less than 1/2
inch, the length can not be more than 8 m.
4. INSTRUCTIONS FOR USE
During operation, the appliance must be placed on a firm and stable surface.
Switched on
Warning: Always turn off the unit's motor before turning off the unit's water supply.
Serious motor damage can occur if the unit is run without water.
1. Fully open the water supply faucet.
2. Unlock the trigger (by first pressing the safety button and then pulling the trigger) for a
few seconds; Let the water run out of the nozzle.
3. Check for water leaks from the joints. If there are water leaks, please reconnect the water
hose, spray gun or lance to make sure all accessories are connected perfectly.