14
III.
Auto Skip Lower-Speed HDDs
Enter function "6.3 Minimum Speed" to setup minimum required speed of target HDDs. The system will
isolate any HDD which cannot reach the minimum required speed. Users can choose “Don’t care” or set
the speed value among 10/20/40/60~300MB/second. This setting enables to speed up copying and select
HDD speed higher than the setting.
IV.
Auto Skip Lower-Speed Source
Enter function "6.4 Check Source Minimum Speed". This setting enables to setup whether to check
"source minimum speed" when run speed-checking task. Select “Yes” to include source HDD or select
“No” to skip source checking. This function enables to speed up copying speed and setup minimum speed
for source HDD.
14.Troubleshooting When Duplication Fails
Check if too many bad tracks on HDDs can cause duplication failures.
Check the setting of function "6.2 Skip Error".
Make sure all HDDs are properly and firmly connected.
Go to “5.1 Show Disk Info" and press UP DOWN to check HDD info.
Make sure the capacity of source HDD is smaller than target.
[Utility]
1. Show Disk Info
[02] SATA 149GB
ST3160318AS
[Minimum Speed]
100MB/Second
[Check Source Minimum Speed]
No
