ArcSource Outdoor 24 MC Integral SmartWhite
13
Pon Time
---
Power On Time.
Use the menu item to read the number of operation hours of the fixture.
Total
- the function shows the total number of the operation hours since the ArcSource Outdoor 24
MC Integral has been fabricated.
Reset
- the function shows the number of the operation hours that the ArcSource Outdoor 24 MC
Integral has been powered on since the counter was last reset.
In order to reset this counter to 0 you have to press and hold the UP and DOWN buttons and at the
at the same time press the ENTER button.
DM In
---
DMX values
. Select this function to read DMX values of each channel received by the fixture.
Temp
---
Fixture Temperatures.
Select this menu to read the temperatures of the fixture:
Current
--- the current temperature of the fixture inside.
Highest
- the menu item shows the max. temperatures of the fixture inside since
the ArcSource Outdoor 24 MC Integral has been fabricated.
High Res.
--- the menu item shows the maximum temperatures of the fixture inside since
the counter was last reset. In order to reset this counter to 0 you have to press and hold the UP
and DOWN buttons and at the at the same time press the ENTER button.
Measuring points: Led-temperature on the PCB with LEDs
Board- temperature on the control board of LEDs
Note: The ambient temperature should not exceed 40°C.
The temperatures can be displayed in either °C or °F units - see option “tEM.U“ in the menu “Pers“.
Sw Ver
---
Software Versions.
Select this function to read the software version of the fixture processors.
6.3 Personality
Use this menu to modify the ArcSource Outdoor 24 MC Integral operating behaviour.
DMX Pres
---
DMX preset
. Select this menu item to set a desired DMX mode. Please refer to the chapter "DMX
protocol" for detail description of each DMX mode.
DMX In
---
DMX input
.
Use the menu to select mode of receiving DMX signal:
Wired
-
DMX signal is received by means of the standard DMX cable.
Wireless
-
DMX signal is received by means of the inbuilt wireless module (wireless DMX version
only).
M FTime
---
Max. Fade time.
Select this menu item to set a desired max. fade time (0-25.5 sec.). This adjusted fade
time influences fade of Red, Green, Blue,White and dimmer during DMX operation:
If time between two receiving DMX values is > than fade time set in the item “M Ftime“, the entire adjusted fade
time will be used.
If time between two receiving DMX values is < than fade time set in the item“M Ftime“, the adjusted fade time will
be reduced to fill entire time between the two receiving DMX values.
e.g “M Ftime“=2sec. and fixture has received Red=0 DMX, after 5 seconds will receive Red=255 DMX. It means, that
red will go to full intensity during 2 seconds.
“M Ftime“=8 sec. and fixture has received Red=0 DMX, after 5 seconds will receive Red=255 DMX. It means, that
red will go to full intensity during 5 seconds. (Max, fade time is reduced from 8 sec. to 5 sec.).
Display.
---
Display adjusting
. This function allows you to change the display settings.
Turn
-
This function turns the display by 180°.
On/Off T
-
This function allows you to keep the display permanent on or turn it off two minutes
after last pressing any button on the control panel.
