6
2.
RJ45 patch cables category 5 that connect the ArcPower SmartWhite 72 each other are wired 1:1,that is,pins
with the same numbers are connected together.
Pin 1:
Not used
Pin 1:
Not used
Pin 2:
Not used
Pin 2:
Not used
Pin 3:
Not used
Pin 3:
Not used
Pin 4:
Not used
Pin 4:
Not used
Pin 5:
Not used
Pin 5:
not used
Pin 6:
Data +
Pin 6:
Data +
Pin 7:
Data -
Pin 7:
Data -
Pin 8:
GND
Pin 8:
GND
5.Installing instructions.
5.1.DMX operating
1.Unplug from the mains before installation.
2.Connect the LED modules to the fixture.
3.Connect the DMX controller to the fixture
4.Connect the fixture to the mains
5.Set the DMX address on the control board of the fixture (see chapter "Control board").
Warning!
Accidental connection DMX 512 Input/Output to non-DMX 512 device (e.g.Ethernet
network Hub) can damage the ArcPower SmartWhite 72.
Maximum total cable length between one LED zone output of the ArcPower
SmartWhite 72 and all its connected LED modules is 80 metres.
Single ArcPower SmartWhite 72 installation:
Multiple ArcPower SmartWhite 72 installation:
Connect the DMX output of the first ArcPower SmartWhite 72 with the DMX input of the next ArcPower Smart
-
White 72. Always connect one output with the input of the next ArcPower SmartWhite 72 until all fixtures are
connected.In this way,up to 32 fixtures can be chained together.
At the last ArcPower SmartWhite 72 the data link has to be terminated with a terminator. A termination plug is
simply a RJ45 connector with a 120
Ω
resistor between pins Data (–) and Data (+).Plug terminator in the DMX
output of the last ArcPower SmartWhite 72.
Maximum number of LEDs connected to the one zone of the ArcPower SmartWhite 72 is 36.
Summary of Contents for arcpower smartwhite 72
Page 1: ...version 1 2...
