6
Manual / Function
1. SEMI-AUTO cordless screwdriver
Taking the finger off the lever whenever the device reaches the setting torque while comes along
with clutch DA-DA-DA sound. Continue running after screws are tightened up which is more
than 8~10 clutch noisy may result in overloaded and cause damage of the task.
(1) Trigger switch
When the start switch is pressed into 1/3 trip, the front end light will be turn on for operation.
When it reach from half trip to full trip , the screwdriver begin to start impact from low speed to
maximum speed until the default timer is reched for each H/M/L torque level.
Screwdriver will stop by release the start switch or the H/M/L default operation time is reached.
For safety and power consumption consideration, screwdriver will automatic stop after 30 seconds
operation.
(2) Forward / Reverse switch
When push the Forward/Reverse switch to the right. According to the symbol
on the switch,
the screwdriver rotates clockwise and tightens the screws. When push the switch to
the
screwdriver will rotate anti clockwise and loosen the screw. When the screwdriver is idle, set the
Forward/Reverse switch in the middle.
Forward (screw)
Reverse (unscrew)
(3) LED light
While press the trigger, the LED lights up automatically to assist the job to be done; on the
contrary, it will be off once the trigger has been released.
(4) Bit sleeve
Switch the screw bit and compatibility, pull the head of the type B screwdriver, and install the bit
according to the diagram below, after installing the bit please also install the W type cap and push
it in following the arrow indicated on the diagram below on Diagram 2.
Pull the bit holder
Insert the bit
Insert the Socket
Extension
Diagram 1
Diagram 2
Summary of Contents for MYTORQ MYBT-SC0408
Page 11: ... ...
