9
8. CONFIRM mode
Code
Description
Disable method
C1
Once external confirmation “GATE”
External GATE Signal
Trigger once
C2
Twice external confirmation “GATE”
External GATE Signal
Trigger twice
C3
When
『
OKALL disable screwdriver
』
function is on, LCM
will display
『
C3
』
after a batch completed.
Panel Enter button/
External CONFIRM
C4
When
『
OKALL disable screwdriver
』
＆
『
Gate mode_ trigger once
』
functions are on LCM will display
『
C4
』
after a batch completed.
External GATE Signal
Trigger once +Panel Enter
/External CONFIRM
C5
When
『
OKALL disable screwdriver
』＆『
Gate Mode_ trigger twice
』
functions are on
；
LCM will display
『
C5
』
after a batch completed.
External GATE Signal
Trigger twice +Panel
Enter/External CONFIRM
NS
When error occurs, LCM will display
『
NS
』
Panel Enter button/
External CONFIRM
BS
When turn on the Barcode Enable, "BS" will be displayed before the
job is executed.
Barcode scan function
OK
When screwdriver shut off, LCM will display
『
OK
』
NA
OKALL When a batch is completed
，
LCM will display
『
OK ALL
』
NA
NG
NG-F
：
Sequence incomplete
NS-F
：
Press Confirm/Enter for next action.
NGQ: When output torque isn’t inside set torque range. Output torque
could be lower than“LQ”or higher than”HQ”
NGC: When number of output shaft rotation isn’t inside set range. No.
of rotation could be lower than“LC”or higher than”HC”.
Sequence incomplete: 1NG-F means sequence 1 is not completed
properly, 2NG-F means sequence 2 is not completed properly… and so
on.
NA
E3
Voltage-drop protection
：
When the voltage of the electric screwdriver
drops instantly, the electric screwdriver will be stopped, and the LCM
displays this symbol, representing that the screwdriver is currently
under low-voltage protection.
NA
E4
Over-temperature protection
：
When the internal temperature of the
electric screwdriver is too high, the electric screwdriver will be
stopped, and the LCM displays E4, representing that the screwdriver is
currently under over-temperature protection.
NA
E5
Stall protection
：
When the startup of the electric screwdriver motor is
abnormal, the electric screwdriver will be stopped, and the LCM
displays E5, representing that
the screwdriver is currently under motor stall protection.
NA
E7
Torque abnormal: When sensor received the abnormal parameters form
screwdriver, it will stop the actions of the screwdriver and display E7
symbol on the LCM.
NA
E8
Temp cooling down state: When the screwdriver enters the temperature
protection, it will stop the action of the screwdriver and display E8
symbol on the LCM.
NA
E9
Abnormal operation: When the screwdriver runs continuously for more
than 20 seconds, it will stop the action of the screwdriver and display
E9 symbol on the LCM.
NA
