WALL ASSEMBLY
IMPORTANT:
When drilling into walls, always check that there are no hidden wires or pipes etc.
Make sure that the screws and wall plus supplied are suitable for supporting the unit.
Consult a qualified person if you are not sure.
WARNING:
Position the Heater carefully. It must not be in front of or below a power socket. It
must not be below a shelf, curtains or any other obstruction. The heater has to be
installed at least 0.1m above the floor.
WARNING:
The case of heater gets warm during normal operation; therefore, for wall mounting,
please ensure that the wall surface is suitable. Some wall coverings may be affected
by the high temperature.
Wall Mounting (optional)
NOTE: Position in reach of a power outlet.
1. Decide on the position of the heater on the
wall, using a spirit level mark two level points
420mm apart for the top mounting brackets.
See pic 1.
2. Drill these two holes (holes 1 and 2) using an
6mm diameter drill and 35mm deep, insert two
wall plugs
and using two screws
fix the
two top brackets in the correct orientation.
See
pic 3.
(Note the brackets are L-shaped, to
ensure that the bracket tabs are facing inwards
towards each other.
See pic 2
).
3. Fit the two remaining brackets extending
backwards with their tabs facing downwards
using the same screws and holes.
See pic 4.
4. Mount the heater on the wall brackets fitted
at step 3 above through the slots on the rear of
the heater and ensure that the heater is level
and fully hooked onto the brackets slots. You
can now mark the position of holes 3 and 4.
5. Remove the heater and using the 6mm drill,
drill the two holes (3 and 4) 35mm deep and
insert two wall plugs . Finally remount the
heater onto the top brackets and using the
remaining two wall screws
,
fix the bottom
pic. 1
(hole position sketch)
pic. 2
pic. 3
