Copyright © 2018 AudioNote Kits
www.AudioNoteKits.com
Page 58
10.1.2 Initial Wiring of the Output Transformers
Position and secure the Output Transformers with the supplied hardware.
For each transformer,
Solder the 7" wire from the Black speaker post to the Green lug on the transformer.
Solder the 7" wire from the middle Red speaker post to the Blue (middle) lug on the
transformer.
Solder the 7" wire from the upper Red speaker post to the Purple lug on the transformer.
Using the wire from the OP Transformer bag, prepare the following wires:
2 Red wires of approximately 7". These MUST be long enough to reach from the Red lugs of
the Output Transformers to the A2 pads on the ECF80/EL34 PCB.
2 Black wires of approximately 7". These MUST be long enough to reach from the Black lugs
of the Output Transformers to the A1 pads on the ECF80/EL34 PCB.
For each transformer,
Solder a 7" Red wire to the Red lug on the transformer.
Solder a 7" Black wire to the Black lug on the transformer.
Position and secure the ECF80/EL34 PCB. We'll make the remaining connections from the
speaker posts and Output Transformers to the ECF80/EL34 PCB in the Interwiring section
below.
