Copyright © 2018 AudioNote Kits
www.AudioNoteKits.com
Page 56
10.1.1 Wiring the Speaker Posts
Here's a diagram of what we're going to do next:
Note: The following wiring instructions use only Red and Black wires as your kit may be
supplied with only Red and Black wires, in lieu of the Red, Black, Blue, Green, and Purple shown
in the diagram above. Again, don't worry! Just be sure to connect the right points together and
check the chart at the end of the Interwiring section and all will be well!
Using the wire from the OP Transformer bag, prepare the following wires:
2 Black wires of approximately 7". These MUST be long enough to reach from the Black
speaker posts to the Green lugs on the Output Transformers.
2 Black wires of approximately 9". These MUST be long enough to reach from the Black
speaker posts to the solder pads marked '0L' and '0R' on the ECF80/EL34 PCB.
