Anita GARUDAN GPS/G-4032, User'S Manual And Spare Parts Book

Page: 34 / 101

ANITA ©
MP01700EN_161116 34
9) TROUBLESHOOTING
No. Type of the problem Cause of the problem Solution
1
Error of control
system or machine
driving unit
Error message on the display of
needle motor driver for X or Y axis
Inform manufacturer about
the type of error message
Fuse is short - cut Check fuses in the
switchboard
Switched - off circuit breaker Check position of the circuit
breaker in the switchboard
Error message on the machine
display
Act in accordance with type
of error message and
information from the
operation manual
2
Wrong needle upper
stop position
Wrong setting of parameter for
needle upper stop position angle
or parameter of reverse angle
Check correct s etting of
following parameters :
25 Reverse angle
26 Up stop position angle
35 Reverse angle before
wiper
Wrong position of needle motor
sensor or sensor plate
Check position of needle
motor sensor plate and the
sensor function
Fault of needle motor or motor
driver
Exchange motor for needle
driving mechanism or
respective driver in the
switchboard
3
Wrong position of
feed frame
Loose n screws leading to slipping
of driving toothed wheels of X and
Y axis
Check if screws of feed
frame driving wheel
mechanism are properly
tightened
Wrong fixing of the sewn product
Correct proper fixing of the
sewn material inside the
template
Loss of X - or Y - motor steps
Lower the sewing speed
and check if there are not
any mechanical obstacles
preventig motor or feed
frame from fluent
movement
4
Fault of needle
Damaged needle (bent, broken or
worn -out )
Exchange the needle
Wrong position of needle
Re - install correct positron
of the needle
Contact of needle and position
Set correct clearance
between needle and hook
and check if the hook is not
damaged
www.garudan.cz