2017/04 V.1
66
EN
Container (CNe/CNi)
5.2.6
Clean the filter lid with water distributor
1
Wash the lid in warm water with detergent.
2
Rinse the lid in clean water and dry it.
5.2.7
Clean the blender
1
Wash the blender in warm water with detergent.
2
Rinse the blender in clean water and dry it.
5.2.8
Remove beverage deposits from the inner pot
1
Empty the container. Use the tap.
2
Remove the brewing accessories from the container.
3
Fill half the container with warm water.
4
Put a sachet of coffee fur remover into the water.
5
Stir the water with a spoon to disolve the remover.
6
Wait for approxiamately 15 to 30 minutes, then empty the container. Use the tap.
7
Rinse the inside of the container with clean hot water several times. Use the tap to empty the
container each time you rinse the container.
8
Wipe the inside of the container dry.
5.2.9
Remove beverage deposits from other parts
1
In the bucket, mix 5 liters of warm water with 1 sachet of the coffee fur remover.
2
Put the parts that need to be cleaned into the water.
3
Wait for approximately 15 to 30 minutes, then remove the parts from the receptacle.
4
Carefully discard the water.
5
Rinse the parts with clean hot water. Do this several times.
6
Repeat steps 1 to 5 if coffee deposits are still on the parts.
7
Wipe the parts dry.
Note
You can clean the filter lid with water distributor in a dishwasher.
Note
This procedure also applies to the removal of tea stains.
A sachet of coffee fur remover is required for this procedure. Refer to 2.3.6
Caution
Do not immerse the container during this procedure.
Note
This procedure also applies to the removal of tea stains.
Note
This procedure requires a bucket with at least a 5 liter capacity.
A sachet of coffee fur remover is required for this procedure. Refer to 2.3.6
