Animo
A 200-3
09/99
4
6. BREWING COFFEE
1.
Place the filterpaper (90/250) with the
appropriate amount of coffee (fine ground
for filter coffee units) in the basket filter.
The amount can be measured with the
supplied measuring spoon. Generally
speaking, you will need about 70 - 80
gram per 1.8 l jug.
2.
Place an empty jug on the lower hot
plate.
3.
Check that the machine is switched on,
main switch on (fig. 2B), and switch
on the lower hot plate (fig. 2F).
4.
Turn the selection switch (fig. 2C) to the
required amount.
5.
Press the start switch (fig. 2D).
6.
The orange signal lamp (fig. 2A) on
the machine will now light up and
the filter coffee will be prepared.
7.
When the signal lamp goes out again, the
hot water supply will stop. After about 1
minute, all of the coffee will have been
poured through the filter.
8.
Stir the coffee in the jug briefly and pour,
or place the full jug on one of the upper
hot plates. The upper hot plate can be
switched on separately using the appropriate
switch (fig. 2E) or switch on the third hot
plate (fig. 2G).
9.
The machine is ready to be used again after
the basket filter has been cleaned.
4. CONTROL PANEL
A - Signal lamp for heating element
B - On/off switch
C - Selection switch for full or half jug
D - Start switch
E - On/off switch for upper hot plate
F - On/off switch for lower hot plate
G - On/off switch for third hot plate
5. PREPARATIONS BEFORE USE
The following procedure should be carried out
before a new machine is used.
1.
Connect the supplied water hose to the
coupling nut swivel joint at the rear of the
machine and to a manually-operated
water tap.
ATTENTION!
Use cold water only.
2.
Slide the basket filter into the machine
and place an empty jug on the lower hot
plate.
3.
Put the plug of the third hot plate into the
female connector at the back of the
machine. After you have followed the
instructions above, place the plug in the
socket.
4.
Turn the machine on using the switch
(fig. 2B).
5.
Turn the selection switch (fig. 2C) to the
desired amount.
6.
Press the start switch (fig. 2D) and the
water reservoir will fill up.
7.
The orange signal lamp (fig. 2A) will now
remain lit until the water has run through.
The machine is ready for use when the
light has gone out again.
