Animated Lighting, Inc PAGE 5
1) CONNECTION:
Locate the RJ45 (8-pin) jacks inside each of your light controllers. Connect
one end of a CAT 5 network cable into the open RJ45 jack of your original controller. Run the
other end of the cable out of the hole in the bottom of the box, and into a hole on the bottom of
the expansion controller. Plug that end into one of the available RJ45 jacks on your expansion
controller.
2) ADDRESSING:
Locate the two dials on the same board as the RJ45 (8-pin) jacks. Below these
dials are designations “A1” and “A0”. We have listed in the diagram above the network addresses
that are needed for each light controller above the picture of each light controller.
1
2
Four-Pumpkin Face Package
FACES 1 AND 2
“1” (A1) “4” (A0)
INITIAL
CONTROLLER:
BUSHES AND TREES
“0” (A1) “0” (A0)
FACES 3 AND 4
“1” (A1) “5” (A0)
The Four Pumpkin Face package is designed to use either Qty. 2 or Qty. 3 light controllers. You
will only need Qty. 2 light controllers if you are only going to have the Qty. 4 Pumpkin Faces
sing to the music. If you want to control not only the Pumpkin Faces, but also have the lights on
your bushes, trees, flood lights, black lights, and strobe lights dance to the music, you will need
a third controller. We will identify this as “Initial Controller” in the diagram below. In either
scenario, you will need to daisy chain from the Monster Brain to the controllers with a Category
5 network cable as shown below.
MBX32
PWR
Audio
Port 1
Port 2
Play
Term
MP3 DMX
HB SD IP
