WARNING: IMPORTANT SAFETY INFORMATION:
Inspect before use for any damage to the unit or power cord. Any damage or missing parts
should be reported immediately and before attempting use. Units with ANY damage to the
power cord should not be used.
Failure to follow these instructions and warnings may lead to product damage or personal
injury of which
Angelo Décor International Inc.
will not be held responsible or liable.
1. NEVER leave children unsupervised or out of sight around ANY pond
environment.
2. Always unplug power from lights, pumps or other electrical devices BEFORE
putting hands in water, or if service and maintenance is performed.
3. Always use properly grounded (GFCI) electrical equipment and a drip loop on any
power cords to prevent water from travelling along the cord.
4. Keep the power cord away from high temperatures.
5. Do not exceed the voltage as indicated on the transformer.
6. Do not submerse the transformer in water.
7. Always use a cloth when handling the lens or bulb. Oil from your skin can
damage the bulb.
8. Do not use near flammable liquids.
9. Do not use in temperatures below 3
0
Celsius as freezing damage may occur.
TIPS BEFORE INSTALLATION
Ensure the seal, lens, and protective ring are
clean, free from debris, and form a tight seal
when fully assembled.
Assess the angle you will require and
adjust the unit before placing in pond.
Determine if colored lenses will be used before placing the unit in pond.
Choose an area for your transformer that will protect it from heat sources, excess
water, dirt and debris.
Use landscape materials such as stones to hide excess cord, taking care not to
puncture or damage the cord in any way.
INSTRUCTIONS FOR USE
1. Assemble and adjust the housing unit WITHOUT PLUGGING IT IN.
2. Place the unit in water on a flat surface with unobstructed access to the feature you
wish to illuminate, keeping plug socket end out of water.
3. Attach the light cord plug socket firmly
to the transformer.
4. Screw the socket cap nut on hand tight.
5. Plug transformer into a GFCI outlet, KEEPING IT OUT OF THE WATER.
REPLACING THE BULB
Should the bulb burn out, replacements are available.
DISCONNECT UNIT FROM POWER SUPPLY BEFORE HANDLING.
Allow unit to cool before attempting to change the bulb. Please use a cloth when handling
the bulb as oils from your skin can damage the bulb.
1. Disassemble the protective
ring by turning counterclockwise
2. Remove Lens
3. Gently unplug the bulb from the housing socket.
4. Replace Bulb
5. Reassemble the unit, ensure seal in place, close protective ring
tightly, turning clockwise.
