Installation Guide
Angel Armor Ballistic Door Panel (Level IIIA) for Chevy® Tahoe PPV
970 235 2961 [email protected] angelarmor.com
10
Inserting the Ballistic Door Panel
1
Adjust the window height to 7.5”.
2
Turn off the ignition switch and remove the
key.
3
Disconnect the vehicle battery to avoid
accidental airbag deployment.
4
Lift up on the outer window weatherstrip to
remove it from the door.
Use caution when removing parts that may
have sharp edges, such as the outer window
weatherstrip.
5
Bend the bottom of the ballistic panel
away from you, pressing with your knee
or hand. This creates a slight curve in the
ballistic panel that matches the shape of the
bottom of the Chevy Tahoe door and eases
installation.
NOTE:
Do not bend the ballistic door panel
tighter than a 6” radius (12” diameter).
6
Hold the ballistic door panel so that its
anti-abrasion panel faces the interior of the
vehicle.
7
Leading with the bottom edge of the ballistic
door panel, begin to insert the panel into the
door, adjacent to the outer surface of the
window glass.
NOTE:
Hold the ballistic door panel against
the window glass as you insert to avoid
obstructions inside the door. This can be
achieved by lightly leaning back/pulling the
panel out toward the exterior of the door.
8
Slide the ballistic panel down into the door,
following the edge of the window frame.
Figure 11. Removing the outer window weatherstrip
Figure 12. Inserting the Angel Armor Ballistic Door Panel into
the door
