AIRLUX
6
2.3
Mounting the Trims
Before running the power cables through the fan, mount the trims on the down rod.
The down rod has two trims: One on the upper side and another on the lower side. To distinguish the upper
side from the lower side, check the form of the rubber ball joint. The flat part of the ball joint corresponds to the
upper side of the rod.
The trim on the upper side is secured by means of a retaining washer. The narrow side of the washer should
look upwards. Once the receiver connections are finished, secure the trim by tightening the screw.
The trim on the lower side is inserted in the lower part of the down rod with the rubber (narrow) side facing
upwards.
2.4
Preparing the Wires
The power cable must run through the down rod. To do so, unlock and move the ball joint on the upper side by
untightening the screws and remove the pin.
Once you have run the cable through the rod, return the ball joint to its original position
2.5
Securing the Down Rod to the Engine
Follow the following steps:
1. Remove the pin from the lower side of the rod
2. Untighten the screws on the engine support
3. Insert the down rod in the engine support
4. Secure the pin
5. Tighten the screws on the engine support
Once the above steps are finished, mount the trim to cover the engine support.
