AndyMark Robot Competition Table Assembly Manual Download Page 3

Page: 3 / 4

Inner Section Panel

Inner Section Wall

3. Center Section Assembly

2X - Inner Section Wall

1X - Inner Panel

For more information visit AndyMark.com/Table

6X - Washer

6X - Screw

6X - Spacer

1. Align walls to edges of the inner panel with the flat side

of the panel facing up. Each hole in the panel should line

up with a corresponding hole or threaded insert in each

wall.

2. Add a screw, washer and spacer to each of the 6 large panel

holes. The 4 holes on the edge will be used in a later step.

Thread the screw into the threaded insert and leave loose

until all the screws are installed.

Screw

Spacer

Washer

3. Adjust the walls and ensure the outside edges of each wall are aligned with the edge of the base panel. Using an

1/8” allen wrench, secure wall sections to the base panel.

Summary of Contents for Robot Competition Table

Page 1: ...X Washer 22X Spacer 2X Outer Panel 1X Inner Panel 8X Dowel 1 Insert Dowels into Outer Panels Locate the two Outer Panels and 8 Dowels Using a mallet or Light Duty Hammer gently insert dowels into hole...

Page 2: ...connects into the walls so that it lines up with the holes in the wall and panel Make sure the back of the angle is facing towards the inside of the table Use a screw and washer to secure the wall and...

Page 3: ...in the panel should line up with a corresponding hole or threaded insert in each wall 2 Add a screw washer and spacer to each of the 6 large panel holes The 4 holes on the edge will be used in a late...

Page 4: ...ble Use a screw and washer to secure the wall and Interconnect to the panel Leave these screws loose until all screws are installed 3 Add a screw washer and spacer to each of the remaining panel holes...