Interconnect A
Outer Section Panel
Outer Section Side Wall
Interconnect B
Outer Section Side Wall
West Wall
2. West Section Assembly
1X - Interconnect A
1X - Interconnect B
2X - Outer Section Side Wall
1X - West Wall
1. Align walls to the corresponding edges of panel with the
flat side of the panel facing up. Each hole in the panel
should line up with a corresponding hole or threaded insert
in each wall.
1X - Outer Panel
For more information visit AndyMark.com/Table
12X - Washer
12X - Screw
8X - Spacer
2. Insert the Interconnects into the walls so that it lines up
with the holes in the wall and panel. Make sure the back of
the angle is facing towards the inside of the table. Use a
screw and washer to secure the wall and Interconnect to
the panel. Leave these screws loose until all screws are
installed.
3. Add a screw, washer and spacer to each of the remaining
panel holes. Thread the screw into the threaded inserts in
each side wall and
leave loose
until all the screws are
installed.
Screw
Outer Section Side Wall
Washer
Interconnect B
Screw
Spacer
Washer
4. Adjust the walls and ensure the outside edges of each wall
are aligned with the edge of the base panel. Using an 1/8”
allen wrench, secure wall sections to the base panel.
