AndyMark Robot Competition Table Assembly Manual Download Page 1

Page: 1 / 4

AndyMark

Robot Competition Table Assembly Guide

v1.0 10/7/20

Included Parts & Hardware

Required Tools

Mallet

1/8” Allen Wrench

#2 Phillips Screwdriver

4X - Outer Section Wall

2X - Inner Section Wall

1X - East Wall

1X - West Wall

4X - Flat Head Screw

30X - Washer

22X - Spacer

2X - Outer Panel

1X - Inner Panel

8X - Dowel

1. Insert Dowels into Outer Panels

Locate the two

Outer Panels

and 8 Dowels. Using a mallet or Light Duty Hammer, gently insert dowels into

holes on the edge of each Outer Panel. Approximately half the dowel should protrude when fully inserted.

The inner panel

does not

recieve any dowels.

For more information visit AndyMark.com/Table

30X - Screw

2X - Interconnect A

2X - Interconnect B

Summary of Contents for Robot Competition Table

Page 1: ...X Washer 22X Spacer 2X Outer Panel 1X Inner Panel 8X Dowel 1 Insert Dowels into Outer Panels Locate the two Outer Panels and 8 Dowels Using a mallet or Light Duty Hammer gently insert dowels into hole...

Page 2: ...connects into the walls so that it lines up with the holes in the wall and panel Make sure the back of the angle is facing towards the inside of the table Use a screw and washer to secure the wall and...

Page 3: ...in the panel should line up with a corresponding hole or threaded insert in each wall 2 Add a screw washer and spacer to each of the 6 large panel holes The 4 holes on the edge will be used in a late...

Page 4: ...ble Use a screw and washer to secure the wall and Interconnect to the panel Leave these screws loose until all screws are installed 3 Add a screw washer and spacer to each of the remaining panel holes...