18
Rear side of the remote controller
Fig. 1
Winding around the notches
Pass the remote
controller cords
through the notch.
Section A
Insulating cover
(Do not remove
the cover.)
Mounting bracket
Remote controller cords
4. Secure the remote controller cords by winding
them around the notches as shown in Fig. 1.
For wiring inside the wall
For exposed wiring
5. Attach the remote controller to the mounting bracket.
Insert the bottom of the remote contoller into
the groove at the bottom of the bracket and
push in the 2 hooks on top of the remote
controller completely.
* If it is dificult to attach, do not try to force it as it
may result in broken hooks. Check for proper
alignment in the groove or for loose wires obstructing
the remote controller.
* Do not install on the
bracket by force, the
hooks may break.
Hooks
Groove
Mounting
bracket
Main remote
controller body
6. Secure the remote using the machine screws.
7. Attach the decorative frame which was removed
in the second step.
Push the 4 corners of the decorative frame until
there is a click.
* Incomplete installation may result in failures
such as switch operation failure.
Note: To remove the decorative frame after
installation of the remote controller and
the frame, pull the entire decorative frame
forward while pressing the sections
indicated (where the
fi
ngers are) in the
fi
gure below.
* If it does not come off, insert a flat head
driver into the notch at the bottom of the
decorative frame and slightly twist it to
remove (due caution is required not to
scratch the remote controller, decorative
frame or the wall in doing so).
Click
Click
Click
Put fingers into this gap.
Main remote
controller body
Machine screw
(accessory part)
Click
