background image

 

 

 

 

 

 

                                                  Andrew Corporation – Base Station Systems Group                                                Page 1 

Proprietary – Use pursuant to Company Instruction 

Introduction: 

 

The  OneBase™ Cell Extender subrack is a high-power, mixed-mode RF front-end 
equipment solution which provides signal amplification and conditioning for both uplink 
and downlink cellular base station signals.  It is a highly modular design, consisting of a 
minimal set of unique field-replaceable units, capable of being configured and scaled for 
a variety of system level capacities and air interfaces including TDMA, GSM/EDGE, 
CDMA, WCDMA and analog air interfaces.

 

 
 

System Specifications: 

 

System specifications for the OneBase™ Cell Extender Subrack are:  

Parameter 

Specification 

Frequency Bands 

  850 MHz Band Tx:   869-894 MHz 
1900 MHz Band Tx: 1930-1990 MHz 
25 MHz   (29 MHz for -20dB bandwidth, nominal) 

Operation Bandwidth 

60 MHz   (70 MHz for -20dB bandwidth, nominal) 

Input / Output Impedances 

50 Ohms 

Supply Voltage 

+21 VDC to +30 VDC 

Nominal Passband Gain (dB) 

55 dB     +/- 1 dB 

Power Amplifier Module Power 
Rating 

135 Watts 

Subrack Capacity 

4 MCPAs 

Total Rated Mean Output Power 

426 Watts  (+56.3 dBm) 

Supported Output Power (Typical) 

40 Watts/carrier  (WCDMA) 
25 Watts/carrier  (TDMA) 
25 Watts/carrier  (CDMA) 
25 Watts/carrier   (GSM/EDGE) 

DC current draw 

<140 Amps per Subrack 

In-Band emissions 

-13 dBm/MHz 

Receive Path Noise Figure 

3.5 dB 

 

Summary of Contents for OneBase Cell Extender









Reviews: