Figure 20
Subreflector
Installation and
Adjustment
Step 1
30
Installation Procedures
Failure to conform to the following alignment procedures may result in non-com-
pliance to antenna performance specification.
Carefully raise the completed subreflector assembly into place with the reflector in the
zenith position. Attach the subreflector assembly to the reflector as shown in Figure 20.
Note:
All INTELSAT Type Approved antennas do not require further subreflector adjust-
ment after performing Steps 2 thru 8. All Type Approved antennas are required to have the
subreflector mechanically set per the instructions on page 30 and Figure 21 of this manual.
3/8”
Hex Nut
(9999-60)
3/8”
Lock Washer
(9974-63)
3/8”
Flat Washer
(9997-145)
302767
Subreflector Strut
3/8 x 2-1/4”
Hex Head Capscrew
(9963-127)
3/8”
Flat Washer
(9997-145)
302518
Subreflector Strut
Support Bracket
Reference Drawing 240272
IMPORTANT
