Cleaning and Maintenance
•
Always switch off the appliance and allow it to cool completely before cleaning.
•
Do not immerse this appliance in any liquid as this will damage it.
•
The thermostat has a manual reset function. To use this, press the reset button
on the main housing.
To ensure your Hot Water Dispenser works as efficiently as possible, it’s important
that you descale it regularly. The harder your water, the more regularly it will need
to be descaled. It’s recommended that you do this once a month. This can be done
by following the instructions below.
CAUTION
-
Remove the Purify Filter before descaling.
The Purify Filter must be
replaced if it is in contact with descaling solution.
•
You can use white vinegar or shop bought descaler to descale your Hot Water
Dispenser.
1.
If you are using vinegar, use one cup of vinegar to one cup of water and follow
steps 3 to 6 below . With shop bought descaler, follow the instructions on the
packet.
2.
Pour at least 1 litre of the solution into the appliance’s water tank,
3.
Set the unit at 0 degrees celcius and 000 volume, press the OK button and
dispense 300ml (one cup full) of solution which can be returned to the water
tank.
4.
Allow the product to stand for 15 minutes.
5.
Repeat step 4 for a further 2 cycles.
6.
Set the unit at 0 degrees celcius and 000 volume, press the OK button and Run
the water through the appliance until the tank is empty.
7.
Fit the Purify filter and fill the water tank. To finish, rinse the appliance and
repeat step 7 once more to ensure fully descaled.
After cleaning, open the drainage stopper on the underside of the base and empty
out the waste water. Replace the drainage stopper and secure before using the
appliance again.
Note:
Descaler can be bought from all good supermarkets.