Failure to follow these instructions may result in fire, electrical
shock, or risk of injury to persons.
•
Do not place the appliance near a naked flame, hot gas or
electric burners, or any appliances generating heat.
•
Always
remove the plug safely from the socket after use. Do not
pull from the cord.
Appliance Specific Safety Instructions
•
This appliance generates heat. Please take adequate protections
against the risk of burns, scalds, fires or other damage caused by
heat.
•
Never use the appliance without sufficient water in it, or allow it to
boil dry.
•
Always operate this appliance with a suitable container placed
below the dispensing nozzle.
•
Do not place this appliance on or near any gas or electric burner or
inside a heated oven.
Before First Use
1.
Check that the water drain screw on the base is tightened.
2.
Prepare and fit the purify filter
3.
Fill the tank with cold water.
4.
Hold the lock button to unlock the control screen.
5.
Set the unit at 0 degrees celcius and 000 volume, press the OK button and
dispense 2 litres of cold water.
6.
Set the unit at 100 degrees celcius and 000 volume,
press the OK button and
run until a further 1 litre of water is dispensed.
7.
The unit is now cleaned and calibrated ready for use.
8.
Caution – steam is vented into the water tank, be aware of hot surfaces when
refilling the tank.
9.
In the locked condition the product is in standby mode to maintain the
calibration settings. If the power is disconnected, repeat the calibration
procedure