DN:KD-5917-SMSY01 V3.0
Operation Guide
Template version:1
7/15
c.
You can turn off the monitor by pressing “START” button when the minute is
blinking, then the time and date is confirmed.
d. The monitor will turn off automatically after 1 minute of no operation with the time
and date unchanged.
e. Once you change the batteries, you should readjust the time and date.
3. CONNECTING THE CUFF TO THE MONITOR
Insert the cuff tubing connector into the socket in the left side of the monitor. Make
certain that the connector is completely inserted to avoid air leakage during blood pressure
measurements.
Avoid compression or restriction of the connection tubing during measurement
，
which may cause inflation error, or harmful injury due to continuous cuff pressure.
4.
APPLYING THE CUFF
a. Pulling the cuff end through the medal loop (the cuff is
packaged like this already), turn it outward (away from your
body) and tighten it and close the Velcro fastener.
b. Place the cuff around a bare arm 1-2cm above the elbow joint.
c. While seated, place palm upside in front of you on a flat surface
such as a desk or table. Position the air tube in the middle of
your arm in line with your middle finger.
d. The cuff should fit comfortably, yet snugly around your arm.
You should be able to insert one finger between your arm and the cuff.
Note:
1.
Please refer to the cuff circumference range in
“SPECIFICATIONS” to make
sure that the appropriate cuff is used.
2.
Measuring on same arm each time.
3.
Do not move your arm, body, or the monitor and do not move the rubber tube
during measurement.
4.
Stay still, calm for 5 minutes before blood pressure measurement.
5.
Please keep the cuff clean. If the cuff becomes dirty, remove it from the monitor
and clear it by hand in a mild detergent, then rinse it thoroughly in cold water.
Never dry the cuff in clothes dryer or iron it. Clean the cuff after the usage of
every 200 times is recommended.
5. BODY POSTURE DURING MEASUREMENT
