Anderson STACKPRO 5400, Diagnostics Manual

Page: 7 / 60

Model(s) : Stackpro
The Danfoss touchscreen display
dont want to turn ON
Bale carrier
Diagnostic procedure
Inspect the fuse located next to the
« kill switch » to turon ON/OFF the
computer. Replace if needed
The fuse is burned. I putted a
new one and it burned out
instantly when i turn the
computer ON
Protocol to inspect bad wired
blowing up the fuses #003
Use a voltmeter to test your battery
port connection. A minimum voltage
a 12V is required
Use a voltmeter to test your battery
port connection. A minimum voltage
a 12V is required for the touchscreen
Danfoss display to work properly.
Inspect the wires from the battery,
and search for a cutted wired, or
improperly inserted wired in the
connectors.