42
12.2
Remote Starter
Characteristics
This electric starter system, also called an engine kill, can only start or stop the Honda gas
engine. It includes a module that is installed on the interior of the rear chassis on the right side
and connected to the engine. It also includes a small remote control (Figure 12.3). The remote
control has 2 buttons. The small green button (upper left corner) starts the engine. The red
button (in the center) stops the engine. A red blinker briefly turns on when it is activated.
Remote Control
We remind you that the small green button (upper right corner) starts the engine. The red
button (in the center) stops the engine. A red blinker turns on briefly when the remote control
is used to indicate that the internal battery is in good condition. In case of failure, the remote
control will itself try 2 more times to start the engine. Finally, be aware that your small remote
control is not waterproof.
Figure 12.3
Functions of remote start
Caution!
The remote control is not waterproof.
Start Up
Do not forget to turn the engine key to ON before using your remote control. If you do not do
this, the remote control will not work. You can leave the engine switch in ON position for
several weeks without starting the engine.
Caution !
If the engine does not start after the first try, the receiver will try two
more times automatically.
Programming
If your remote starter was installed in the factory, your remote control has probably already
been configured. If not, or if this is a new remote control, here are the configuration
instructions:
1 – Move the engine switch to OFF.
2 – Hold down the red button while simultaneously moving the switch rapidly to ON, OFF, and
ON.
3 – Release the red button and press the green button. Your engine will start.
Malfunction
Reprogram your remote control or check the battery
C
A
B
