PRODUCT MANUAL
28/34/40ST Below Deck Compact Motor
™
10
STEP 4
Fit drain tube.
4.1 Remove the plastic plug from the drain port fitting and push
the drain tube [A14] into the fitting until it stops. Lead the drain
tube below deck to a low point in the boat where it can drain to
the bilge, then cut off any excess length. At most there should
only ever be a drop or two of water from condensation that will
pass through the tube.
STEP 5
Install push button
The push button requires 50mm (2”) clearance depth below the
mounting surface. It is supplied with a short 190mm (7 1/2”) long
cable lead; this is connected below deck to the 1000mm (39”) long
control cable [A12] and then to the short cable leads from the motor.
Extension cables are available and may be ordered separately if
necessary.
5.1 Select the desired location. For safety reasons it is
recommended that the push button [A1] is located in close
proximity to the winch, preferably within reach.
5.2 Determine the preferred orientation of the hinged cover (on
vertical surfaces it should open upwards). Then using the
drilling template or the rubber gasket [A2] as a guide, drill a
Ø25mm (1”) hole.
5.3 Drill a Ø3mm (1/8”) hole in each of the three mounting screw
locations.
5.4 Fit gasket and push button in place. Secure the push button unit
with the 3x M4x20mm self tapping screws [A10], using a small
amount of sealant at each hole.
5.5 Ensure that the breather channel on the side of the through-deck
tube of the push button is clear and free of dirt or sealant.
Plastic plug
removed from
drain port
Drain port fitting
Breather
channel
Drilling
template
Mounting
screws
Hinged
cover
Push
button
Rubber
gasket
Push button installation
