ANDERIC.COM
RR2HDCOM
4
times represents the first digit of code. Note: If digit is 0, the LED will not flash.
b. Press and release keys
[MUTE]
and
[2]
simultaneously, then release. The LED flashing
times represents the second digit of code.
c. Press and release keys
[MUTE]
and
[3]
simultaneously, then release. The LED flashing
times represents the third digit of code.
d. Press and release keys
[MUTE]
and
[4]
simultaneously, then release. The LED flashing
times represents the fourth digit of code.
Note: If digit is 0, the LED will not flash.
Single Press Combined POWER Key
Note: This feature is enabled by default
.
About:
This allows for powering on/off both your TV and STB (Set-top-box) with one press of the POWER
button. If enabled, pressing POWER key will send code for power for both units. If disabled, pressing
POWER key will only send code for TV. If you wish to first select which mode to send code for power, you
must disable the “TV punch-through” as well, steps below.
1. Press and hold
[S]
and
[ENTER]
keys simultaneously for about three seconds until indicator light
lights and remains on, release both keys.
2. Device mode indicator light will light. It doesn’t matter which mode lights.
3. Input code [
9] [9] [9] [5]
.
a. Enabled – (0 blinks): If LED turns off directly after inputting the four digits, this indicates
that “one key power-off all devices” was successfully
Enabled;
b. Disabled – (2 blinks): If LED blinks 2 times after inputting the four digits, this indicates that
“one key power-off all devices” was successfully
Disabled
.
After one key power-off all devices successfully
enabled
, press [POWER] key, it will send STB Power
immediately followed by TV Power code.
STB (set-top-box) Punch-Through Function
Note: This feature is enabled by default. STB keys effected:
0,1,2,3,4,5,6,7,8,9, ENTER, PREV CH, CC,
CH+, CH-.
About:
This allows for locking all STB keys to always “punch-through” to the STB mode’s assigned codes.
This locks the STB keys to always send codes for STB mode, no matter what mode the remote currently
resides.
1. Press and hold
[S]
and
[ENTER]
keys simultaneously for about three seconds until indicator light
