AND UM-212BLE, Instruction Manual

Page: 39 / 176

7 3 h s il g n E
Normal measurement
Place the cuff on the arm.
Sit quietly during measurement.
When in standby mode or measurement
standby mode, press the START/STOP
button.
All of the display segments are displayed.
Zero (0) is displayed blinking briefly. The
display changes, as indicated in the figure
at the right, as the measurement begins.
The cuff starts to inflate. It is normal for
the cuff to feel very tight.
Note: If you wish to stop inflation at any time,
press the START/STOP button again.
3. When inflation is complete, deflation starts
automatically and (heart mark) blinks,
indicating that the measurement is in
progress. Once the pulse is detected, the
mark blinks with each pulse beat.
Note: If an appropriate pressure is not
obtained, the device starts to inflate
again automatically.
To avoid re-inflation, see “Measurement
with the SET Pressure” on the next
page.
4. When the measurement is complete, the
systolic and diastolic pressure readings
and pulse rate are displayed.
The cuff exhausts the remaining air and
deflates completely.
5. Press the START/STOP button to carry out the measurement again.
The device will proceed to standby mode automatically when no operation
is made for a regular time. And when the START/STOP button is pressed
and held, device will proceed to standby mode.
Exhausts remaining air
automatically