AND UA-767F, Instruction Manual

Page: 15 / 60

English 14
Systolic pressure
Diastolic pressure
WHO classification
Pulse rate
START
Measurements
Before measurement, read “Notes for Accurate Measurement” on the next page.
Normal Measurement
1. Press the SET button to select a user from 1 to 4.
2. Place the cuff on the arm (preferably the left arm).
Sit quietly during measurement.
3. Press the
START
button.
All of the display segments are displayed.
Zero (0) is displayed blinking briefly.
The display changes, as indicated in the
figure at the right, as the measurement
begins. The cuff starts to inflate. It is normal
for the cuff to feel very tight. A pressure bar
indicator is displayed, on the left edge of the
display, during the inflation.
Note: If you wish to stop inflation at any time,
press the
START
button again.
4. When inflation is complete, deflation starts
automatically and (heart mark) blinks,
indicating that the measurement is in
progress. Once the pulse is detected, the
mark blinks with each pulse beat.
Note: If an appropriate pressure is not obtained,
the device starts to inflate again automatically.
To avoid re-inflation, see “Measurement
with the Desired Systolic Pressure” on
the next page.
5. When the measurement is complete,
the systolic and diastolic pressure
readings and pulse rate are displayed.
The cuff exhausts the remaining air and
deflates completely.
6. When not recording the measurement
data, press the or button.
7. Press the
START
button to turn the device off.
After one minute of non-operation,
the device will turn off automatically.
At heart level
Measurement
in progress
Exhausts remaining
air automatically
Press
Pressurizing
Zero display
Starts inflation
All of the display
segments displayed