MADE IN USA
TWO YEAR WARRANTY
ProLink 500™ Wireless Intercom Owners Manual
For System Setup & Operation Videos Visit Our Website: www.anchoraudio.com
AnChor Audio Customer serviCe
800.262.4671
For AdditionAL inFormAtion
visit www.anchoraudio.com
6
PROlINk 500 TECHNICAl SPECIFICATIONS
(Specifications Subject to Change Without Notice)
FCC ID: J8ZBP-500
ProLink Belt Pack (BP-500)
RF Frequency Range
902-928MHz
Modulation FSK
Range (line of sight)
Duplex 500’ / 75 m
Antenna
1/2 - wavelength dipole
Power Supply
9VDC, 1.2ADC
Battery Life
12 hours
Weight
15oz. / 0.42kg (with batteries)
Dimensions
4.5 “x 6.25” x 3.75”
(114.3 x 158.75 x 95.25 mm)
Single-Ear (H-2000S & Dual-Ear Headphones H-2000)
Drivers
Dynamic, 40mm
Impedance 300
W
+/- 15%
Frequency Response
20Hz - 20kHz
SPL
91dB +/- 3dB
Rated Power
> 40mW
Distortion
< 5%
Microphone
Dynamic, Uni-directional,
Low impedance
Mic Sensitivity
Referenced to 0dB=1V/μbar, 1kHz
Min -85 dB / Typical -83 dB /
Max -81 dB
Frequency Response
200Hz-12kHz
Connector Plug
4-pin XLR, female
Weight
Single: 13 oz. / 0.37 kg
Dual: 16 oz. / 0.45 kg
Warning: Changes or modifications not expressly approved by Anchor Audio, Inc.
could void the user’s authority to operate this device. Only use the provided belt-clip.
TROUblESHOOTING
Can’t hear a person speaking?
First, verify that the MASTER belt pack is ON and within range of each of the REMOTE belt packs.
Second, increase headset volume using the headset volume knob on the top of the belt pack. In
extremely loud environments, you will need to use the dual ear muff headset with noise cancelling
properties. If you still can’t hear, your batteries may be dead. Also, verify each belt pack is on the
same channel.
Microphone not picking up your voice?
First, adjust the microphone sensitivity setting on the top of the belt pack by turning the blue button
incrementally until you reach desired sensitivity level. Move the microphone closer to your mouth
and speak up clearly. For example, some people speak softer than others and need a more sensitive
microphone level.
background noise transmitting across system?
Reduce the microphone sensitivity setting by turning the blue button until you reach the desired level.
Transmission is weak?
Your rechargeable batteries may be running low. If batteries are weak, the green LED on the top panel
will flash. Your belt pack batteries need to be recharged. If you need to keep working, you can use
disposable alkaline batteries.
Proper intercom usage
Up to 4 people may talk at once. Use proper intercom etiquette – don’t “talk over” others while they
are speaking. Also, position the microphone to pick up a minimum of breath noise.