ACCLAIM LECTERN
- TABLETOP
All Models
4
ACCLAIM LECTERN - CONTROL PANEL
Model Shown: ACC-6000U1
NEED MORE HELP? View demonstration videos on proper system setup and operation:
www.anchoraudio.com/acclaim.php
BASIC SYSTEM OPERATION
NOTE: Fully Charge Battery Before First DC Use!
1. Set all Input Level Controls to minimum & Tones Controls to flat
(the middle setting) before turning your system on
2. Plug lectern gooseneck microphone into the Lectern Mic Jack
located on the tabletop
3. Plug reading light into the Reading Lamp Jack on control panel
4. Switch POWER to ON, the BATTERY LED will light
5. Slowly increase the Level Control for the input jacks used
to the desired volume
6. Adjust BASS & TREBLE controls to desired sound quality
IMPORTANT: Make all connections w/ shielded
cables to avoid hum, buzzing or interference.
LECTERN
MICROPHONE
JACK
BACK/CONTROL PANEL
FRONT/SPEAKER
LECTERN TOP
UHF WIRELESS RECEIVER
Available on selected models only
(please see page 6 for instructions)
TONE CONTROLS
Bass & Treble
WIRED MICROPHONE
LEVEL CONTROL
LECTERN MIC
LEVEL CONTROL
POWER ON
INDICATOR LIGHT
READING LAMP JACK
Remove
cap to use
LINE IN LEVEL
CONTROL
AUXILIARY MICROPHONE
INPUT JACK – XLR
Balanced - low impedance
microphones, powers con-
denser mics
SPEAKER OUT
OUTPUT JACK – 1/4” PHONE
Balanced - drives an unpowered
2 ohm speaker in addition to the
built-in speakers
CHARGE INDICATOR LIGHT
(please see page 3 for instructions)
BATTERY LEVEL INDICATOR LIGHT
ACCLAIM LECTERN -
CONNECTION PANEL
Model Shown: ACC-6000U1
LINE IN
INPUT JACK – 1/4” PHONE
Jack may be combined w/ mic inputs for a composite output
For playback of tape/CD player or other audio source
LINE OUT
OUTPUT JACK – 1/4” PHONE
Balanced - provides combined
output of all active system inputs
Record presentation / connect to another
powered sound system
INTERNAL SPEAKER SWITCH
Turn internal lectern speaker
output on / off
BALANCED MICROPHONE
OUTPUT JACK – XLR
Use to connect Acclaim to a
house system
