6
2. Approvals and Usage
Notice: This radio transmitter (IC: 8975A-A16020401) has been approved by Industry Canada to operate with
the antenna types listed below with the maximum permissible gain and required antenna impedance for each
antenna type indicated. Antenna types not included in this list, having a gain greater than the maximum gain
indicated for that type, are strictly prohibited for use with this device.
Avis: Cet émetteur radio (IC: 8975A-A16020401) a été approuvé par Industrie Canada pour fonctionner avec
les types d’antennes énumérés ci-dessous avec le gain maximal admissible et l’impédance d’antenne requise
pour chaque type d’antenne indiqué. Les types d’antennes ne figurant pas dans cette liste, ayant un gain
supérieur au gain maximal indiqué pour ce type, sont strictement interdits pour l’utilisation avec cet appareil.
Item
Numéro d’article
Part Number
Référence
Manufacturer
Fabricant
Type
Catégorie
Gain (dBi)
Gain
1
Integral part of A43364A
Partie intégrante de A43364A
Anaren
Integral antenna
Antenne intégrée
2
2
66089-2406
Anaren
Monopole whip, 6mm lead
Antenne monopôle, longueur 6mm
3
3
66089-2430
Anaren
Monopole whip, 30mm lead
Antenne monopôle, longueur 30mm
3
2.1.2.1. IC Labeling Requirements
From section 3.2.1 RSS-Gen, Issue 3, December 2010,
Labeling Requirements for the Host Device:
The host device shall be properly labeled to identify the modules within the host device. The Industry Canada
certification label of a module shall be clearly visible at all times when installed in the host device, otherwise
the host device must be labeled to display the Industry Canada certification number of the module, preceded
by the words “Contains transmitter module”, or the word “Contains”, or similar wording expressing the same
meaning.
From section 5.2, RSS-Gen, Issue 3, December 2010,
Equipment Certification Numbers and Labels
:
Every unit of Category I radio apparatus certified for marketing and use in Canada shall bear a permanent label
on which is indelibly displayed the model number and Industry Canada certification number of the equipment
model (transmitter, receiver, or inseparable combination thereof). Each model shall be identified by a unique
combination of a model number and a certification number, which are assigned as described below in this
section.
The label shall be securely affixed to a permanently attached part of the device, in a location where it is visible
or easily accessible to the user, and shall not be readily detachable. The label shall be sufficiently durable to
remain fully legible and intact on the device in all normal conditions of use throughout the device’s expected
lifetime. These requirements may be met either by a separate label or nameplate permanently attached to the
device or by permanently imprinting or impressing the label directly onto the device.
The label text shall be legible without the aid of magnification, but is not required to be larger than 8-point font
size. If the device is too small to meet this condition, the label information may be included in the user manual
upon agreement with Industry Canada.
Section 5.2 continues: