Anaren A110LR09x, User Manual

Page: 13 / 38

A110LR09x
– User’s Manual
Page 13 of 38
Release Date 10/31/11
Contains Transmitter Module FCC ID: X7J-A11072401
-or-
Contains FCC ID: X7J-A11072401
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
2.1.2. End User Manual
The end user manual should include the following statement:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.

Consult the dealer or an experienced radio/TV technician for help.
2.2. Canada (Industry Canada, IC)
The A110LR09A and A110LR09C modules have been certified for use in Canada under Industry Canada
(IC) Radio Standards Specification (RSS) RSS-210 and RSS-Gen.
From section 3.2 RSS-Gen, Issue 3, December 2010, Modular Approval for Category I Equipment or
Category II Equipment:
“Modular approval permits the installation of the same module in a host device or multiple host devices
without the need to recertify the device. Equipment certification for a modular device may be sought for
either Category I equipment or Category II equipment.