Analytik Jena CyBio Well vario OL3381-25-300, Operating Manual

Page: 137 / 164

CyBio
®
Well vario Release: 2017 121
Maintenance & Care
sure that tip magazine is correctly placed on completion of work.
6. Reconnect power plug to mains socket and turn CyBio
®
Well vario power on at
the main switch.

The system will be re-initialized and becomes operational again.
9.2.8 Sealing Plate (Pipetting Head)
You are advised to follow these rules:
1. Do not use pipette tips covered with dust.
2. Check sealing plate for cleanness once in a month.
3. Trigger a tip changing cycle and remove the tip magazine for inspection and
cleaning. The sealing plate can now be accessed from the bottom. Use a non-
shedding slightly moistened cloth for cleaning.
4. Proceed with utmost caution in order to prevent unwanted position-shifting of
the sealing plate. Otherwise, there is danger of plate openings getting clogged
with fluff balls.
5. Do not remount the tips, until the sealing mat has fully dried.
9.2.9 Compressed Air Control Unit – Draining Condensate
Regularly check the view glass at the compressed air control unit for condensate level. If
liquid can be perceived in its lower part, hold a piece of cloth below the drain screw and
remove condensate by releasing the drain screw (
→
see fig. 116 ).
Fig. 116: Compressed air control unit - condensate drain outlet
NOTE
Where pipette tips are changed at shorter intervals, fine fluff-ball stock or dust may set-
tle on the sealing plate, thus impairing the efficiency of sealing.
CAUTION
Danger! Splashing!
When draining condensate, hold a piece of cloth underneath the drain screw.