6
* Specifications subjects to change without notice.
Installation
MOUNTING
Mount the unit in a DRY location. Allow at least 4 inches of clearance around the heat sink
fins for adequate cooling. .
POWER CONNECTION
The unit is supplied with power leads about 3 feet long. This should normally be adequate to
connect to a source of power. If you must extend the power leads, be sure to use at least a
good quality (typeTEW) AWG 8 gauge wire. The wire colours are:
All connections should be made inside an appropriate junction box. Refer to the specifications
table for the correct sizing of the circuit breaker in the distribution panel.
If the power is connected in reverse, the input fuses will blow. Remove the top cover of the
charger to replace them.
Red - Positive
Black- Negative
Mechanical Specifications
Depth
13.5 in / 34.3 cm
Width
19.0 in / 48.3 cm
Height
3.5 in / 8.9 cm
Clearance
1 inch (2.5 cm) all around
Material
Marine Grade Aluminium
Finish
Black Anodize / Powder Epoxy Coat
Fastenings
All 18.8 Stainless Steel
Weight
7.6 lb / 3.3 Kg
Connections
Four contact output terminals
Warranty
3 years
Designed and manufactured by:
ANALYTIC SYSTEMS WARE (1993) LTD.
8128 River Way
Delta, BC V4G 1K5 Canada
p. 604.946.9981 f. 604.946.9983
tf. 800.668.3884 US/Canada
www.analyticsystems.com
[email protected] Revised August 2014
