MASTER TUNE
This tune control affects both VCOs.
Note; there are lots of ways this synth can play out of tune. Obviously Master Tune and
Detune must be set correctly. But also the MODULATION AMOUNT controls will affect
tuning and also the positions of the sequencer’s VCO1/2 DESTINATION amount
controls.
DETUNE
This tune control only affects VCO2.
GLIDE
This is a portamento function. Each note will glide to the next new note, slowly rising or
falling in pitch to the new note. The Glide knob changes the rate (time) it takes to reach
the new note.
MANUAL PULSE WIDTH (VCO1 ONLY)
This changes the pulse width (duty cycle) of the square wave. Basically turn it and hear
the effect it has on the sound of the square wave!
PULSE WIDTH MODULATON
This allows modulation of the square wave’s Pulse Width. On VCO1 it can be modulated
by the LFO Triangle wave. On VCO2 by Envelope 1.
SYNC (VCO 2)
Oscillator sync is where the VCO’s waveform can be reset by
another signal. Don’t worry about the technicalities. Just use
the feature and enjoy the sound!
VCO2 can be sync’ed to VCO1 Square wave, or it can be
Analogue Solutions 2021 02
