Analog Devices EVAL-ADPD6000, User Manual

Page: 11 / 20

User Guide EVAL-ADPD6000
VSM CLIENT
analog.com Rev. 0 | 11 of 20
Figure 33. Reading Individual Register
Figure 34. Writing Individual Register
6. If a Fail to read register or Fail to write register pop-up
appears (see Figure 35 ), check whether the device is discon-
nected or broken.
Figure 35. Error Message when Configuring Individual Register
RECEIVE THE DATA
Take the following steps to receive data from the FIFO after running
the EVAL-ADPD6000Z:
1. After connecting the device and loading the configuration file,
click Plot View to view the Plot View interface and click the run
button (see Figure 36 ).
Figure 36. Plot View Interface
2. The waveform appears in the Plot View page (see Figure
37 ). If the waveform is out of scale, select the Enable Y-axis
Adaptation check box to adapt the vertical scale of the plot to
the waveform scale.
Figure 37. Waveform
3. To adjust the dots number on the x-axis, select a value from the
X-axis dots number dropdown menu (see Figure 38 ).
Figure 38. Change X-Axis Dots Number
4. To view the waveforms of different slots and channels, select
the check boxes under PPG Show lines (see Figure 39 ). Fig-
ure 39 shows slotA-Channel1 and slotB-Channel1 selected.
Figure 39. Select Slot and Channel Waveforms
5. Click Start Export to begin exporting the data received (see
Figure 40 ), and click Stop Export to stop exporting the data
locally (see Figure 41 ). The exported data is saved in an .xlsx
file. Before clicking Stop Export , clear the Enable Y-axis
Adaptation check box. If this check box is selected, the da-
ta may fail to save. If the export is successful, a Success
to export data pop-up appears (see Figure 42 ) noting the
location of the .xlsx file as follows: C:\Analog Devices\VSM
Client\VSM_Client\Export . In the Export folder, the file name
notes the date, time, and corresponding function of the export
(see Figure 43 ).